The following photos represent the use of our CGU Kit guards and CGSplit guards. We stock these CGU Kit guards come in 7 different sizes and can be easily customized in both the length and height dimensions. The CGSplit guards are custom built to your specifications.

This is a custom barrel guard with inspection window being installed on a vertical mixer in a papermill.

This is the 1st Uniguard barrel guard designed and installed on a Durco Mark 3 Group 4 High-Capacity Chemical Process Pump.

28″ high custom machine guard. Direct replacement and drop-in.

Here is a reciprocating pump that is featuring a vertical belt guard.

Our nonmetallic, lightweight machine guards won’t dent or rust and are UV protected against sunlight. Vertical Guards incorporate solid panels in the front and rear of the guard with a vertical split in the center of the guard. Shaft openings are located and field cut, usually with a hole saw. The belt guard easily slips over the equipment, maintaining guards OSHA/ANSI Compliance. For more details and options, review the information on the following page:

Belt Machine Guards

Previously used guards and the modified barrel guards for a water supplier in Ontario Canada.

These are custom guards being used to protect against the rotating shaft in the seal area of these pumps at a potato chip manufacturer. OSHA has been citing these exposed areas on pumps as a potential source of hazard since there is a hand reachable rotating shaft exposed here on many pumps.

Uniguard Kit Machine Guard used at a steel mill.

A variety of Uniguard Machine Guards used at a chemical plant.